Depending on the material being embossed, either standard embossing jaws (up to 35 HRC) or high-end embossing jaws (up to 45 HRC)
can be used

Steel.

Hardened.

The wear of the embossing jaws can be checked with the test blocks. If these are too worn, safe clamping can no longer be guaranteed.

Step 1: Loosen the screws (3) and place the embossing jaw (1) on the body (6).
Step 2: Slide the embossing jaw (1) onto the positioning slides (2) or the embossing slides. Check that the embossing jaw (1) is securely guided over the center.
Step 3: Press the embossing jaw (1) onto the body (6) and secure the embossing jaw (1) firmly to the positioning slide (2) or the embossing slide using the screws (5).
Step 4: Press the plate (4) onto the body (6) and secure it firmly to the embossing jaw (1) using the screws (3)

41219 Embossing station SOLIDStamp.
41221 Center marking device SOLIDStamp.
41222 Test blocks for jaw wear SOLIDStamp.